PREGUNTAS FRECUENTES

The Evolution Cover has a water resistance that will help keep your plate dry. Laminated canvas and aluminum keep water out, however manufacturers leave spaces in the bed such as drains and slots that allow water to enter. Additionally, the gates of the trays do not have gaskets that seal the entry of water (unlike the door of a car) and some other slots, as in the photo, have spaces to put other accessories, which if they are not covered will also present entries. of water. In short, no plate or cover on the market is 100% waterproof and anything that cannot get wet must be protected.

It really is very easy, just open the plate hatch, pull the cable from either end and be surprised by the smoothness and speed of the cover. You can even roll it in and out with just one hand.

Yes. The Evolution Cover will only block the bottom of the rear window at 1/3 the size of an average pick-up truck.

4 or 6 clamps are used depending on the size of the plate that secure the side rails where the cover works. These clamps secure to the edges or side flanges of the bed and for all trucks that come with internal flanges NO drilling is required. Basic tools are used and installation takes around 1-2 hours depending on the vehicle. The space occupied by the roller system is around 17-19 cm in diameter (approximately depending on the length of the plate). On the other hand, it is necessary to drill only on the pickups that do not have internal tabs, but external ones like the reference pickup. Only some versions come from the factory with these tabs facing out. Inside these vans are some versions of: Toyota Hilux Mahindra Pik-Up Chevrolet D-Max Nissan Frontier D21, D22.